Table of Contents
Advertisement
DTP2/XTP/HDBT output connector (output 1B) — This connector and the HDMI
F
output connector (1A) are mirrored, meaning that they display the same image (see
figure 3
on page 12 and
Connect a DTP or DTP2 receiver, an XTP matrix switcher, or an
•
HDBaseT-compatible receiver to this RJ-45 twisted pair Out connector. For cable
wiring and recommendations, see
and HDBaseT Connectors
This output also allows for remote powering of DTP and DTP2 receivers, as well
•
as over-DTP analog audio which matches the 5-pole analog audio output of the
receiver.
To transmit or receive infrared data to and from a sink connected to
•
the DTP/DTP2/HDBaseT receiver or XTP matrix, connect a control
device to the 3-pole IR Over TP captive screw port (see
IR pass-through port
The output 1B connector corresponds to the following front panel LEDs (see the
illustration at right):
Signal LED — Lights when the scaler is sending a signal.
•
Link LED — Lights when a valid link is established.
•
ATTENTION:
•
Do not connect this connector to a computer or telecommunications network.
•
Ne connectez pas ce port à des données informatiques ou à un réseau de
télécommunications.
•
DTP remote power is intended for indoor use only. No part of the network that
uses DTP remote power should be routed outdoors.
•
L'alimentation DTP2 à distance est exclusivement réservée à un usage en
intérieur. Un réseau utilisant une alimentation à distance ne peut pas être routé
en extérieur.
DTP Mode
HDCP-compliant digital video
•
•
Embedded audio into the TMDS output
or analog audio
•
DTP standard IR pass-through signals
on the associated 3-pole captive screw
connector
•
Ethernet insertion of RS-232 control
signals (see
RS-232 and IR Signal
Insertion
on page 47)
•
Remote power to a DTP receiver
IN1806 and IN1808 Series Scaling Presentation Switchers • Installation
figures 4 through 6
on page 13).
Twisted Pair Recommendation for DTP, XTP,
on page 22.
on the next page).
Signal Support
XTP Matrix and HDBaseT Mode
HDCP-compliant digital video
•
•
Embedded audio into the TMDS
output
•
IR pass-through signals on the
associated 3-pole captive screw
connector
•
Ethernet insertion of RS-232 control
signals (see
Insertion)
Over TP
G
RS-232 and IR Signal
15
Advertisement
Table of Contents
