Extron electronics IN1806 Series User Manual page 77

Command
Output Configuration (continued)
HDMI Output Format
Set output format
View format setting
View auto output format
KEY:
X@
= Output
X4*
= HDMI output format and colorspace 0 = Auto — HDMI RGB Full to a CEA sink, or DVI to a non-CEA sink
Power Save
Set power save mode
View power save mode
KEY:
X6@
= Power save mode
IN1806 and IN1808 Series Scaling Presentation Switchers • SIS Configuration and Control
ASCII Command Response
(Host to Scaler) (Scaler to Host)
EX@ X4* }
* VTPO Vtpo
EX@ } X4*]
VTPO
EX@ } X4*]
*VTPO
1 = HDMI/DVI output 1A
2 = DTP2/XTP/HDBT output 1B
3 = HDMI/DVI Loop output
1* = DVI — RGB 444, 0-255. Valid for output rates up to 165 MHz
2 = HDMI RGB Full — RGB 444, 0-255
3 = HDMI RGB Limited — RGB 444, 16-235
5 = HDMI YUV 444 Limited — YUV 444, 16-235
7 = HDMI YUV 422 Limited — YUV 422, 16-235
* If the scaler is in DVI mode and a rate greater than 165 MHz is selected,
the HDMI output defaults to HDMI RGB 444 Full.
EX6@ }
PSAV Psav
E } X6@]
PSAV
0 = Full power mode (default)
1 = Lowest power state — TP remote power and over TP functions
are disabled.
2 = Low power state — Over TP and TP remote power are enabled.
Additional Description
X@ X4*] Set the colorspace and format for HDMI
*
output
View the current output colorspace and
format for output
View the output format when
to 0 (Auto).
X6@]
Set the power save mode to
View the current power save mode.
X@ X4*
to .
X@
.
X4*
is set
X6@
.
69