Table of Contents
Advertisement
2.
Edit the network settings as desired:
DHCP — Click the
•
When DHCP is enabled (
settings from the DHCP server. The default is
IP Address, (
•
of these addresses, click in the desired field and enter the address.
3.
When finished editing, click Save to confirm your changes or
window without making changes. You can also close the window by clicking the
upper-right corner of the screen.
NOTE: If DHCP is being enabled, the web page attempts to redirect and connect to the
unit via the unit name (TCP/IP hostname). If a static IP address is being set, the web
page attempts to connect to the new IP address.
RS-232 Panel
The view-only RS-232 panel (see
for the IN1806 and IN1808 Series serial port. The defaults are:
•
Baud rate —
Parity Bit —
•
•
Data bits —
•
Stop bits —
IN1806 and IN1808 Series Scaling Presentation Switchers • Internal Web Pages
button (see
DHCP
), the unit configures its IP address and other network
On
), Subnet mask (
2
3
figure
47,
9600
(none)
N
8
1
figure
55,
) to toggle DHCP on and off.
1
.
Off
), and Gateway address (
Cancel
, on page 103) displays the RS-232 protocol
8
) — To set any
4
to close the
in the
X
110
Advertisement
Table of Contents
