Rs-232 Panel - Extron electronics IN1804 Series User Manual

2. Edit the network settings as desired:
DHCP — Click the DHCP button (see
•
DHCP on and off. When DHCP is enabled (On), the unit configures its IP address
and other network settings from the DHCP server. The default is Off.
IP Address, (
•
of these addresses, click in the desired field and enter the address.
3. When finished editing, click Save to confirm your changes or Cancel to close the
window without making changes. You can also close the window by clicking the X in the
upper-right corner of the screen.
NOTE: If DHCP is being enabled, the web page attempts to redirect and connect to the
unit via the unit name (TCP/IP hostname). If a static IP address is being set, the web
page attempts to connect to the new IP address.

RS-232 Panel

The view-only RS-232 panel (see
IN1804 serial port. The settings are:
Baud rate — 9600
•
Parity Bit — N (none)
•
Data bits — 8
•
Stop bits — 1
•
figure 58
), Subnet mask ( ), and Gateway address (
2 3
figure 49, ) displays the RS-232 protocol for the
8
IN1804 Seamless Scaling Switchers • Internal Web Pages
, , on the previous page) to toggle
1
) — To set any
4
101