Connections And Reset Button; Rear Panel Features - Extron electronics DTP T USW 333 User Manual

Connections and Reset Button

Rear Panel Features

POWER
1
12V
.09 AUDIO
--A MAX
RGB
INPUTS
K K K D D D A A A
Figure 2.
A
C
E
G
I
K
A
B
C
2 3
HDMI HDMI
B B B B B B
DTP T USW 333 Rear Panel Features
RGB input port (input 1)
TP function switch
Over DTP RS-232 and IR port
Remote Contact port
Remote RS-232 port
Power connector
RGB input port (input 1) — Plug an analog (RGB) video source into
the switching transmitter via this 15-pin HD connector. See
connector wiring on page 7 for connector pinout.
HDMI input port (inputs 2 and 3) — Plug HDMI digital video sources into
the switching transmitter via these HDMI connectors (see
on page 8).
These connectors can also accept DVI video with appropriate adapters.
TP function switch — Set this switch as follows, based on the receiver:
ATTENTION:
• Position this switch BEFORE connecting the appropriate device to the
TP connector. Failure to comply can damage the endpoint.
• Positionnez le sélecteur AVANT de connecter l'appareil approprié au
connecteur TP. Ne pas respecter cette procédure pourrait endommager
le point de connexion.
Receiving device is in the Extron DTP series —Set this switch to the DTP position.
The TP output consists of HDMI with embedded audio, analog audio, RS-232 and IR,
and remote power. The switcher and receiver can be powered by one 12 VDC power
supply connected to either unit.
HDBaseT-enabled receiver type —Set this switch to HDBT position. The TP output
consists of HDMI with embedded audio plus RS-232 and IR. The switcher and receiver
each requires its own 12 VDC power supply.
OVER DTP
SIG LINK
HDBT
RS-232 IR
DTP
DTP OUT Tx Rx G Tx Rx
C C C F F F E E E
B
HDMI input ports
D
Audio input port
F
DTP Output RJ-45 port
H
Remote Tally port
J
Reset button
DTP T USW 333 • Installation and Operation
REMOTE
CONTACT TALLY RS-232 RESET
1 2 3 G 1 2 3 + V Tx Rx G
G G G H H H I I I J J J
(see the next page)
(see page 7)
VGA
RGB, Y, R-Y, B-Y
HDMI connector
HDMI
5