Paper Path Selection - Printronix S828 Programmer's Manual

Programmer Manual
ESC [ p1; p2 SP~
Selects emulation (EMU).
ASCII Code
Hexadecimal Value
Decimal Value
This sequence selects the emulation according to p values. The p1 parameter is an emulation identifier
value while p2 is a reset control value.
The proprietary defined parameter values are:
p1 p2
0
1 -20
21
22
0
1
To select ANSI mode from the Proprinter XL 24 mode and maintain the parameters, the sequence would
be: <ESC>[0; 0<SP>~ Leading zeros and defaulting parameters are not guaranteed to be parsed and
therefore should not be used by the application. Parameter p1 & p2 will be expressed as ASCII, not binary,
values. In the example above, "0" is "30H", not "00H".

Paper Path Selection

ESC [ p1; pn p
Assign source for forms.
ASCII Code
Hexadecimal Value
Decimal Value
This command controls the modes of paths for parking, loading paper. The p parameter is an ASCII value.
See the following table:
P PAPER PATH CONTROL
0-7 Reserved
8 Park paper in the current path. Fanfold can be moved backwards for two form lengths. This creates a
"Paper Out" fault condition that exists until paper is loaded from the control panel.
9 Load Paper from the selected paper path.
10 Select and load paper from the Front2 (is the optional Front 2 push tractor assembly is installed).
The current paper will be parked or ejected.
11 Select and load paper from the Front 1. The current paper will be parked.
13 Select and load paper from the Front 2. (is the optional Front 2 push tractor assembly is installed).
The current paper will be parked or ejected.
14 Reserved
Chapter 3 ANSI Emulation Commands
ESC [ p1; p2 SP~
X'1B' X'5B' p1 X'3B' p2 X'20' X'7E'
27 91 p1 59 p2 32 126
FUNCTION
ANSI
Reserved
IBM Proprinter XL 24/24E
EPSON LQ 1050
Hold values (default). The current settings remain valid after changing the printer
emulation.
Full reset. The status of such parameters reverts to defaults dependent on the
selected emulation.
ESC [ p1; p2 p
X'1B' X'5B' p1 X'3B' pn X'70'
27 91 p1 59 pn 32 112
85
PTX‐S828
260071‐001A