Printronix S828 Programmer's Manual page 374

Programmer Manual
SMTP Service
SMTP (Simple Mail Transfer Protocol) allows a mail server address to be entered into the printer
configuration to send automated e-mail notifications with printer alert conditions.
Disabled: Disables the SMTP (Simple Mail Transfer Protocol) service, that is disables the
reception/transfer/error service of the e-mail.
Enabled: Enables the SMTP service, that is it enables the reception/transfer/error service of the e-
mail.
Default is Disabled.
Mail Server Address
These values set the mail server address. This number is represented by a decimal notation where the
decimal values are divided by points in four fields. Each field ranges between 0 and 255.
Default is 000.000.000.000.
Note: Item selection on the printer menu allowed only if the "SMTP Service" function choice is Enabled.
E-mail Address (Receiver)
This function allows writing the e-mail address where you can notify the failures using a 48-character
string. Default is an empty string.
Note: Item selection on the printer menu allowed only if the "SMTP Service" function choice is Enabled.
E-mail Address (Sender)
This function allows to write the sender e-mail address using a 48-character string.
Default is an empty string.
Note: Item selection on the printer menu allowed only if the "SMTP Service" function choice is Enabled.
Location
You can enter the physical location of the printer into this field.
Contact
You can enter a network support contact's name and phone number into this field.
Appendix C– Network Interface Reference 372
PTX‐S828
260071‐001A