Programmer Manual
ESC [ p1; p2 <SP> G
Sets the line/character spacing.
ASCII Code
Hexadecimal Value
Decimal Value
This command sets the spacing between lines (p1 parameter) and the horizontal character pitch (p2
parameter) in decipoints.
If the vertical spacing value exceeds the current form length, this setting is ignored.
Interface Control
NUL
Ignored.
ASCII Code
Hexadecimal Value
Decimal Value
This code is ignored.
ENQ
Enquiry.
ASCII Code
Hexadecimal Value
Decimal Value
This code is used to request the message string defined by the OSC command when parameter p1=8 is
transmitted to the host.
DC1
Selects printer (Data Control 1).
ASCII Code
Hexadecimal Value
Decimal Value
In parallel interface, this code reselects the printer after the printer has been deselected by a DC3 code.
In serial interface, this code is sent from the printer to the host to indicate that the printer is ready to
receive data.
DC3
Deselects printer (Data Control 3).
ASCII Code
Hexadecimal Value
Decimal Value
Chapter 3 ANSI Emulation Commands
ESC [ p1; p2 <SP> G
X'1B' X'5B' p1 X'3B' p2 X'20' X'47'
27 91 p1 59 p2 32 71
NUL
X'00' or NUL
00
ENQ
X'05'
5
DC1
X'11'
17
DC3
X'13'
19
82
PTX‐S828
260071‐001A