Printronix S828 Programmer's Manual page 77

Programmer Manual
ESC [ p1; p2 SP B
Graphic size modification (GSM).
ASCII Code
Hexadecimal Value
Decimal Value
This command sets the height and/or width of expanded and oversized characters.
The p1 and p2 parameters are the percentages by which the height and width will be multiplied,
respectively. The default values of p1 and p2 are 100%.
The maximum expansion factor is18700 for oversize mode and 800 for expanded mode, respectively.
ESC [ p1 t
Special print mode (Oversize/Expanded/Bar code Mode -SPM).
ASCII Code
Hexadecimal Value
Decimal Value
This sequence selects or deselects oversize expanded or bar code mode according to the p1 parameter
value. See the following table:
p1 FUNCTION
0 Cancel special mode
1 Select oversize mode
2 Select expanded mode
3 Select bar code mode
It can select just one special print mode at a time.
SO
Shift out.
ASCII Code
Hexadecimal Value
Decimal Value
This code enables Expanded/Oversize mode as determined by the last received ESC [ p1 t command.
SI
Shift in.
ASCII Code
Hexadecimal Value
Decimal Value
This code disables Expanded/Oversize mode as determined by the last received ESC [ p1 t command.
Chapter 3 ANSI Emulation Commands
ESC [ p1; p2 SP B
X'1B' X'5B' p1 X'3B' p2 X'20' X'42'
27 91 p1 59 p2 32 66
ESC [ p1 t
X'1B' X'5B' p1 X'74'
27 91 p1 116
SO
X'0E'
14
SI
X'0F'
15
75
PTX‐S828
260071‐001A