Printronix S828 Programmer's Manual page 83

Programmer Manual
ESC J or VTS
Vertical tab setting.
ASCII Code
Hexadecimal Value
Decimal Value
This command causes a vertical tab stop to be set to the decipoint value of the current vertical position.
ESC [ p1; pn v
Sets vertical tab stops at specified positions (Multiple Vertical Tab Set -VTS).
ASCII Code
Hexadecimal Value
Decimal Value
This command sets up to 12 vertical tab stops at each decipoint position specified by p parameters. The
tab stops are measured from the top of the page. When specifying more than one position, enter the
parameters in ascending order.
FF
Form feed.
ASCII Code
Hexadecimal Value
Decimal Value
This code causes the data in the print buffer to be printed out and then advances the paper to the top of
the next form.
ESC [ p1; p2; p3 r
Form definition (FD).
ASCII Code
Hexadecimal Value
Decimal Value
This command sets the page length, top and bottom margins.
The p1, p2 and p3 parameters specify the decipoint values.
pn FUNCTION
p1 Page Length
p2 Top Margin Position From the Beginning of the Page
p3 Bottom Margin Position From the End of the Page
The maximum page length value is 15840 decipoints (22 inches).
Chapter 3 ANSI Emulation Commands
ESC J or VTS
X'1B' X'4A' (7-bit) or X'8A' (8-bit)
27 74 (7-bit) or 138 (8-bit)
ESC [ p1; pn v
X'1B' X'5B' p1 X'3B' pn X'76'
27 91 p1 59 pn 118
FF
X'0C'
12
ESC [ p1; p2; p3 r
X'1B' X'5B' p1 X'3B' p2 X'3B' p3 X'72'
27 91 p1 59 p2 59 p3 114
81
PTX‐S828
260071‐001A