Printronix S828 Programmer's Manual page 86

Programmer Manual
ESC c
Resets to initial state (RIS).
ASCII Code
Hexadecimal Value
Decimal Value
This command writes the printer parameters from the stored format assigned to the current path into the
current format.
ESC k
Prints test character (PTC).
ASCII Code
Hexadecimal Value
Decimal Value
This sequence causes one line of the print head test character to be printed.
ESC [ p1; ... pn h
Sets mode (SM).
ASCII Code
Hexadecimal Value
Decimal Value
This command sets a specific print mode according to the parameter value. If the first parameter (p1)is
preceded by a ">" symbol then all parameters are interpreted as proprietary defined parameters. If the ">"
character is not specified, all parameters are interpreted as ANSI defined parameters.
The proprietary defined parameter values are:
p MNEMONIC
1 PRM0
2 CSI
3 BLD
4 CS2
The ANSI defined parameter values are:
p MNEMONIC MODE FUNCTION
0 Ignored
20 LNM Auto CR on LF
ESC p1; pn l
Resets mode (RM).
ASCII Code
Hexadecimal Value
Decimal Value
This sequence resets the print mode(s) indicated by the p1/pn parameter(s).
Chapter 3 ANSI Emulation Commands
ESC c
X'1B' X'63'
27 99
ESC k
X'1B' X'6B'
27 107
ESC [ p1; ... pn h
X'1B' X'5B' p1 X'3B' ... pn X'68'
27 91 p1 59 ... pn 104
MODE FUNCTION
Proportional Print Mode
Single Character CSI Mode
Bold Mode
Character Set 2 Mode
ESC p1; pn l
X'1B' X'5B' p1 X'3B' pn X'6C'
27 91 p1 59 pn 108
84
PTX‐S828
260071‐001A