Connector Pin Layout; 10Base5(Aui) Connector (With D-Sub 15 Pins Retainer); 100Base-Tx/10Base-T Connector (Rj45); External Power Supply Terminal For 10Base5 (12 V Dc) - Panasonic FP2 ET-LAN Technical Manual

2.2 Connector Pin Layout

2.2.1 10BASE5(AUI) Connector (with D-SUB 15 pins retainer)

2.2.2 100BASE-TX/10BASE-T Connector (RJ45)

2.2.3 External Power Supply Terminal for 10BASE5 (12 V DC)

Note:
F.G. pin connects to the external metal shell of the 10BASE5 (AUI), 100BASE-TX/10BASE-T
-
connectors and F.G. pin of the power supply unit.
Pins should be tightened firmly, to a tightening torque of 0.5 to 0.6 N⋅m).
-
The power supply cable should be 0.5 to 2.5 mm
-
should be 7mm.
2-4
Pin No. Signal name
1 Signal shield
2 COL+
3 TX+
4 Signal shield
5 RX+
6 GND
7 Not used
8 Signal shield
Pin No.
1 TX+
2 TX-
3 RX+
4 Not used
5 Not used
6 RX-
7 Not used
8 Not used
Pin No.
1 12 V DC
2 GND
3 F.G.
Pin No.
9
10
11
12
13
14
15
Shell
Signal name
Signal name
2
(AWG20 to 12), and the length of the stripped wire
Signal name
COL-
TX-
Signal shield
RX-
12 V DC
Power supply shield
Not used
F.G.