Panasonic FP2 ET-LAN Technical Manual page 281

System connection information notified area (Bank: 10H)
System connection information notified block (Bank: 010H, Addresses 010H to 03FH)
Offset Name
address
0 Open processing complete code
(System connections 1 to 3)
1 Source node port No.
(System connections 1 to 3)
2 Destination node IP address (L)
(System connections 1 to 3)
3 Destination node IP address (H)
(System connections 1 to 3)
4 Destination node port No.
(System connections 1 to 3)
5 Destination node MEWTOCOL
station number
(System connections 1 to 3)
6 Connection closing time (min.)
7 Reserved
8 Communication method
(System connections 1 to 3)
9 to F Reserved
Note) Only when the auto connection function is valid, the information can be stored in the system
connection information notified block.
Stored value/Explanation
[Stored value]
0: Auto open processing has been completed successfully.
Other than 0: Error code (when auto open processing ended in an
error.)
- Error logs are also stored in the error log area.
[Stored value]
Source node port numbers for various connections
[Stored value]
Destination node IP addresses for various connections after auto
open processing has been completed.
- The value is not entered until auto open processing has been
successfully completed.
[Stored value]
Destination node IP port numbers for various connections after
auto open processing has been completed.
- The value is not entered until auto open processing has been
completed successfully.
[Stored value]
Destination node MEWTOCOL station numbers for various
connections after auto open processing has been completed.
- The value is not entered until auto open processing has been
completed successfully.
[Stored value]
Connection is closed when no communication is performed during
the time specified here.
- The set value is written.
Reserved.
Refer to 10.2.4 "Reading system connection information settings" of
this manual.
Reserved.
15-19