Panasonic FP2 ET-LAN Technical Manual page 194

- Time chart for reading e-mail logs
- Procedure to read e-mail logs
(1) The e-mail log notified request signal is turned ON.
▪ The address 36AH (bit 4) in the e-mail request signal area (Bank: 0) is turned ON.
(2) The e-mail logs (e-mail send log and e-mail receive log) are transferred to the shared memory.
(3) Confirm that the e-mail log complete signal (Bank: 0, Address: 362H, Bit:4) is ON.
▪ Confirm that the address 362H (bit 4) in the e-mail complete signal area (Bank: 0) is ON.
(4) The e-mail send log area (Bank: 11H, Addresses: from 000H) and the e-mail receive log area (Bank:
11H, Addresses: from 200H) of the shared memory are read.
(5) The e-mail log request signal is turned OFF.
(6) The e-mail log complete signal is turned OFF. To read the next e-mail log, be sure to confirm that this
e-mail log notified complete signal has been OFF.
Reference: <Chapter 4 Confirming the Design Contents>
11-26