11.7.1 Request Mail Format
- Format of Request Mail (Sent from a computer)
The format of the request mail to be sent to ET-LAN unit is as follows:
Example of a Request Mail
Necessary settings for the e-mail to be sent
(1) Subject:
Enter "Request" here.
(2) Password:
Enter "Pass=ΔΔΔ" for the first line of the message body. In succession to "Pass=", enter the security
password ("XYZ123" in the example above), which is specified in Receive Option of the Configurator ET,
and finally press the Enter key.
(When the security password is not set, press the Enter key just after entering "Pass=".)
(3) MEWTOCOL command:
Enter the MEWTOCOL-COM command for the 2nd line of the message body.
For "BCC", enter "**" (asterisks).
Reference: For details concerning MEWTOCOL command, refer to Chapter 12.
Note:
-
When entering MEWTOCOL-COM command, the response must not be multiframe. If the response is
multiframe, the error message as shown below is written in the Response Mail and sent back to the
computer.
No good: multi frame
Upper/lower case characters and a space (indicated as "□" here) are discriminated when entering them
-
in the "Subject" column and using them for a password.
OK: "Request"
NG: "request", "REQUEST", "Req□uest", " Request□", and so on.
11-13