Running Test Modes - Panasonic FP2 ET-LAN Technical Manual

3.3.2 Running Test Modes

How the test modes are run
Set the mode setting switches on the rear of the ET-LAN unit to the settings indicated in the table below,
and then turn on the power supply to the programmable controller. When this has been done, either test
mode 1 or test mode 2 can be run. To exit a test mode, turn off the power supply to the programmable
controller.
Switch No.
1 100BASE-TX/10BASE-T
2 Auto connection function is not available
3 Normal mode
4 Test mode 1
Note1) Switching between 100BASE-TX and 10BASE-T is done automatically by auto negotiation
function. Always turn it off when using AFP27901.
Note2) Invalid when the switch 3 is off.
Key Point:
The settings of the mode setting switches become effective at the point when the power supply is turned
on.
Off
Note1)
Note2)
On
10BASE5
Auto connection function is available
Test mode
Note2)
Test mode 2
3-7