Panasonic FP2 ET-LAN Technical Manual page 184

Time chart for e-mail send processing
-
Procedure to send e-mails
-
(1) Write the data that you wish to send via e-mail in the ladder send e-mail setting area.
Reference: Chapter 3.7.2 "Ladder Send E-mail Settings"
(2) The e-mail send request signal is turned ON.
(3) When the e-mail send processing from the ET-LAN unit to the e-mail server is completed
successfully, the e-mail send complete signal is turned ON.
(4) After confirming that the e-mail send complete signal is ON, the e-mail send request signal should be
turned OFF.
(5) When the e-mail send request signal has been turned OFF, the e-mail send complete signal is turned
OFF.
(6) If the e-mail send processing is not successfully completed in some reason, the e-mail send error
signal is turned ON.
(7) Before conducting the e-mail resend processing, be sure to turn OFF the e-mail send request signal
at first.
(8) When the e-mail send request signal is turned OFF, the e-mail send error signal is turned OFF. To
conduct the e-mail resend processing, be sure to confirm that the e-mail send error signal is OFF.
Note:
To send e-mails using the ladder program, the following settings are required.
-
(1) Source e-mail address (This should be specified in advance using Configurator ET.)
(2) SMTP (E-mail) server IP (This should be specified in advance using Configurator ET.)
(3) Ladder send e-mail settings
When all required settings are not specified, an e-mail is not sent even if the e-mail send request signal
is turned ON. The e-mail send error signal is turned ON instead.
Users are notified of the description of the error by means of the error log.
-
Reference:
Presetting procedures for (1) "Source e-mail address" and (2) "SMTP (E-mail) server IP": Control
Configurator ET "Operational Guide Book" (ARCT1F341E)
For (3) Ladder send e-mail settings: Chapter 11.8.2 "Ladder Send E-mail Settings".
11-16