Panasonic FP2 ET-LAN Technical Manual page 79

Offset
Name
address
Partner node
MEWTOCOL
station
5
number
(connections
1 to 8)
6
Partner node
Ethernet
7 address
(connections
1 to 8)
8
9
A Reserved (Used by the system.)
B
If any value is written to these, it should be 0000H.
C
Receive
request data
D size
(connections
1 to 8)
Reserved (Used by the system.)
E
If any value is written to these, it should be 0000H.
Transmission
request data
F size
(connections
1 to 8)
Default
value
[Set value] 1 to 40H (1 to 64)
- Set the station number of the partner node when
MEWTOCOL communication is being carried out.
0000H
- Avoid duplicating the number of another station on the
network.
- This is ignored if MEWTOCOL communication is not being
used.
[Set value] Ethernet address of partner node
When using TCP Active open, if the partner node has no
-
0000H
ARP function, specify this.
Example: If 1.2.3.4.5.6 is set, the offset addresses will be:
0000H
- If "0" or "FFFFFFFFFFFFH" is specified for this value,
0000H
processing will be carried out as though the partner node
has an ARP function.
[Set value] Receive request data size (in byte units)
-This is specified if data is being received in transparent
communication. No receive notification is made until data
equal to the specified size has been received.
0000H - If "FFFFH" is specified, direct reception is carried out (the
receive complete signal goes on each time a packet is
received).
- Specify a size such that the receive request data size is less
than or equal to the size of the receive buffer x 2.
[Set value] Transmission request data size (in byte units)
If data is being sent using transparent communication,
-
0000H specify the size of the data being sent in byte units.
Specify a size such that the transmission request data size is
-
less than or equal to the size of the transmission buffer x 2.
Set value and Explanation
6-11