Panasonic FP2 ET-LAN Technical Manual page 276

Initialization information notified area (Bank 0)
Address Name
2D0H Initialization processing
complete code
2D1H Source node IP address
(L)
2D2H Source node IP address
(H)
2D3H Communication function
setting between networks
2D4H Source node
MEWTOCOL station
number
2D5H Source node Ethernet
(lower address (48 bits)
word)
2D6H
2D7H
(higher
word)
2D8H Reserved (Used by the system.)
2D9H
2DAH
2DBH
2DCH
2DDH
2DEH
2DFH
15-14
Stored value and explanation
[Stored value] 0: Initialization processing was completed successfully.
Other than 0: Error code (Initialization processing ended in an error)
[Stored value] Source node IP address when initialization processing was
completed successfully.
- The written value is the source node address in the initialization
information setting area.
- The value is not valid until initialization processing has been completed
successfully.
[Stored value] 0: Communication function setting between networks is not
used.
1: Communication function setting between networks is used.
- The value is not valid until initialization processing has been completed
successfully.
[Stored value] Source node MEWTOCOL station number when
initialization processing was completed successfully.
- The written value is the source node MEWTOCOL station number in the
initialization information setting area.
- The value is not valid until initialization processing has been completed
successfully.
[Stored value] Source node Ethernet address in the EEPROM
Example: When 1.2.3.4.5.6 has been set:
- The value is not valid until initialization processing has been completed
successfully.