Agilent Technologies 1100 Series Reference Manual page 23

with green light
Figure 5
4 Connect the power cable to the power connector at the rear of the detector.
5 Connect the CAN cable to other Agilent 1100 Series modules. 6 If a Agilent
NOTE
If a Agilent 1100 DAD/MWD/FLD is in the system, the LAN/GPIB should be connected
to the DAD/MWD/FLD (due to higher data load).
7 Connect the analog cable(s) (optional).
8 Connect the APG remote cable (optional) for non-Agilent 1100 Series instruments.
9 Turn on power by pushing the button at the lower left hand side of the
1100 Series DAD and MWD Reference Manual
Front View of Detector
ChemStation is the controller, connect either
•
the GPIB cable to the detector or
•
the LAN connection to the LAN interface board in the detector.
detector. The status LED should be green.
23
Installing the Detector 1