Agilent Technologies 1100 Series Reference Manual page 138

4 Repairing the Detector
1 Turn off the lamp.
2 Switch off the module, and disconnect the cables.
3 Remove module from stack and place it on the working bench.
Figure 33
4 Remove the front cover, top cover and top foam section, see
5 Use a 5-mm and 7-mm wrench to unscrew the REMOTE and the GPIB connector
6 Disconnect all connectors from the detector main board.
When removing connectors, counter-hold with one hand on connector J13.
NOTE
138 1100 Series DAD and MWD Reference Manual
Unscrew Connectors from Board
Cover and Foam"
on page 140.
and a 15-mm wrench to unscrew the nuts of the ANALOG connectors.
"Removing the Top