Entering The Serial Number Using The Control Module - Agilent Technologies 1100 Series Reference Manual

4 Repairing the Detector
11 Refit the screws at the REMOTE and GPIB connectors and the nuts of the
12 Reinstall the top foam section, top cover and front cover, see
13 Replace detector into the stack and reconnect the cables.
If a new detector main board is installed, update the serial number information of the
NOTE
detector in the user interface, see procedure below.
14 Check the firmware revision of the module. If the firmware revision is older than the
The G1315B DAD and the G1365B MWD require firmware revision 4.x or above (main and
NOTE
resident).

Entering the Serial Number using the Control Module

1 Connect the control module to the detector. Turn on the detector.
2 In the control module, press System (F5), then Records (F4). Using the up/down
3 Press FW Update (F5). Now, press the m key. This will display a box which says
4 Press Enter. This will display the box labeled Serial#.
5 Alphabetic characters and numbers are created using the up and down arrows. In the
For firmware revisions below A.02.00 it is important never to press Done if the Serial# box
NOTE
is blank. In this case, the module can no longer be recognized by either the control
module or the Agilent ChemStation. The main board must then be replaced.
6 Turn the detector off, then on again. The Records screen should display the correct
140 1100 Series DAD and MWD Reference Manual
ANALOG connectors.
and the Top Cover"
on page 175.
current firmware revision of the module, update the firmware using the standard
firmware update procedure, see
arrows, make sure that the detector is highlighted.
Update Enter Serial#.
box labeled Serial#, enter the 10-character serial number for the detector. When the
10-character serial number is entered, press Enter to highlight the complete serial
number. Then, press Done (F6).
serial number for this module.
"Replacing the Detector's Firmware"
"Replacing the Foam
on page 180.