14.2 Manufacturers Checklist - Mitsubishi MELSEC-WS0-CPU0 User Manual

Chapter 14
Table 66:
Example of the checklist for
installation of the MELSEC-
WS safety controller
115
Annex

14.2 Manufacturers checklist

Checklist for the manufacturer/installer for installation
of the MELSEC-WS safety controller
The specifications for the following items listed must be available at least for the
initial commissioning. They are dependent on the application, whose requirement
must be checked by the manufacturer/installer.
This checklist should be retained/stored with the machine documentation so that
you can use it as a reference for periodical tests.
1. Have the safety rules and regulations been observed in
compliance with the directives/standards applicable to the
machine?
2. Are the applied directives and standards listed in the
declaration of conformity?
3. Does the protective device comply with the required
category?
4. Are the required protective measures against electric
shock in effect (protection class)?
5. Has the protective function been checked in compliance
with the test notes in this documentation? Especially:
 Functional check of the command devices, sensors and
actuators connected to the safety controller
 Test of all switch-off paths
6. Are you sure that the safety controller was tested fully for
safety functionality after each configuration change?
This checklist does not replace initial commissioning and regular tests by
qualified safety personnel.
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No