Fault Codes; Introduction; Section 4 Fault Codes - Genie S-65 XC Service And Repair Manual

September 2018
Section 4 Faul t Codes
Observe and Obey:
R
Troubleshooting and repair procedures shall be
completed by a person trained and qualified on
the repair of this machine
R
Immediately tag and remove from service a
damaged or malfunctioning machine.
R
Repair any machine damage or malfunction
before operating the machine.
R
Unless otherwise specified, perform each
procedure with the machine in the following
configuration:
· Machine parked on a firm, level surface
· Key switch in the off position with the key
removed
· The red Emergency Stop button in the off
position at both the ground and platform
controls
· Wheels chocked
· All external AC power supply disconnected
from the machine
· Boom in the stowed position
· Turntable secured with the turntable rotation
lock
· Welder disconnected from the machine (if
equipped with the weld cable to platform
option)
Part No. 1288652GT
Before Troubleshooting:
R
Read, understand and obey the safety rules
and operating instructions in the appropriate
operator's manual on your machine.
R
Be sure that all necessary tools and test
equipment are available and ready for use.
R
Read each appropriate fault code thoroughly.
Attempting short cuts may produce hazardous
conditions.
R
Be aware of the following hazards and follow
generally accepted safe workshop practices.
Note: Two persons will be required to safely
perform some troubleshooting procedures.
® ™ ® ™
S -60 XC • S -65 XC
Service and Repair Manual

Fault Codes

Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
97