September - Genie S-65 XC Service And Repair Manual

September 2018

9 A graphic of the machine pitch will now be
shown on the display. By pressing the UP or
DOWN buttons, the graphic will change to
show the counterweight being uphill or
downhill. Select the image that corresponds to
the current pitch of the machine and press OK.
Turntable Pitch
1 uphill
2 downhill
10 The next calibration of the machine is the
machine roll. This is the angle of the machine
from side to side.
11 Place the digital level onto the swing chassis
bearing plate, which is located to the left of the
fuel tank. Orient the level along the roll axis of
the machine.
12 Enter the value as seen on the digital level
onto the ground control display. If the level is
showing a negative value, enter it as a positive
number. Press OK when the value on the
ground control display matches the value of
the digital level sensor (excluding the
plus/minus sign).
Part No. 1288652GT
Turntable Rotation Components
13 A graphic of the machine roll will now be
shown on the display. By pressing the UP and
DOWN buttons, the graphic will change to
show whether the operator is on the uphill or
downhill side of the machine.. Select the image
that corresponds to the current roll of the
machine and press OK.
14 The calibration is now complete.
15 Exit the Service Mode.
® ™ ® ™
S -60 XC • S -65 XC
Service and Repair Manual
Turntable Roll
1 uphill
2 downhill
95