Simotion P Control Manager; Requirement; Simotion P Control Manager Overview; Calling Simotion P Control Manager From The Control Panel - Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual

Parameter assignment/addressing

8.3 SIMOTION P control manager

8.3 SIMOTION P control manager
8.3.1

Requirement

NOTICE
SIMOTION P Control Manager
Because the settings made via the SIMOTION P Control Manager change the factory default
parameters, they should only be made by authorized persons.
8.3.2

SIMOTION P Control Manager overview

The SIMOTION P Control Manager is used to configure the SIMOTION P software.
Call
The SIMOTION P Control Manager is only used by the administrator. Only the administrator
is authorized to make changes.
The SIMOTION P Control Manager is called by means of the operating system's Control Panel.
Properties
SIMOTION P Control Manager has the following features:
● Changes take effect only after a restart via SIMOTION P State.
● The values to be set are generally required only by the administrator.
These values are as follows:
– License handling
– Display of the IP addresses
8.3.3

Calling SIMOTION P Control Manager from the control panel

You can call the SIMOTION P Control Manager in the Windows Control Panel (Start >
Settings > Control Panel).
The call can only be made as administrator. If you are not logged on as administrator, a dialog
will appear notifying you of this fact.
74
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015