Mode Selector - Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual

Note
LEDs for IsoPROFIBUS board
The LEDs BUS1F and BUS2F are only shown if an IsoPROFIBUS board is connected.
Additional references/information
You can find additional information at:
● Diagnostics via LED displays (Page 127) (for a more accurate diagnosis of an LED status)
● Operating displays (SIMOTION P320-4 E / P320-4 S Manual: Information on display
modes, of the SF PROFINET LEDs only displayed on the hardware side, in the operating
displays section)
● PROFINET bus error occurs (Page 132)
7.1.3

Mode selector

Mode selector in SIMOTION P state
Use the mode selector to set the SIMOTION P320-4 to different states. The controller can be
switched in RUN or STOP / STOPU mode and perform an overall reset.
The change of the operating status with the mode selector has priority over a status selected
via SIMOTION SCOUT.
Note
Setting the operating state via the mode selector
The switch position STOP/STOPU cannot be set to RUN via the SIMOTION SCOUT.
To change the operating state, use the mode selector.
Further information
Additional information can be found in the Commissioning and Hardware Installation Manual
for SIMOTION P320-4 E / SIMOTION P320-4 S, in the section Memory reset with the mode
selector (on the screen) (Page 112).
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015
Operator Control (hardware)
7.1 SIMOTION P state application
67