Siemens SIMOTION P320-4 E Commissioning And Hardware Installation Manual page 76

Parameter assignment/addressing
8.3 SIMOTION P control manager
Figure 8-2
Startup
The following settings are possible:
● Enabled
Immediately cancels the block set with Disabled. The SIMOTION P320-4 must be booted
to automatically start the SIMOTION P.
SIMOTION P can also be started by means of the SIMOTION P State application using the
Start SIMOTION P button.
● Disabled
Prevents the automatic starting of SIMOTION P while the Windows system is booting up.
SIMOTION P cannot be started until this block is canceled.
Runtime Network Connections
The Ethernet interface of the SIMOTION P320-4 is displayed here. It an be addressed via
SIMOTION P Runtime.
The IP address can be set here, however, it is not permanent.
76
SIMOTION P Control Manager - Administration tab
SIMOTION P320-4 E / P320-4 S
Commissioning and Hardware Installation Manual, 01/2015