Table 1-1 Function Of Keys - Honeywell UDC 3300 Product Manual

Function of keys
4
Table 1-1 shows each key on the operator interface and defines its
function.
Table 1-1
Key
SET UP • Places the controller in the Configuration Set Up group
select mode. Sequentially displays Set Up groups and
allows the FUNCTION key to display individual functions in
each Set Up group.
FUNCTION • Used in conjunction with the SET UP key to select the
LOOP 1/2 individual functions of a selected Configuration Set Up
group.
• Used to switch the display between Loop 1 and Loop 2
when the controller has a 2-Loop or Cascade configuration.
• Used during field calibration procedure.
LOWER • Selects an operating parameter to be shown in the
DISPLAY lower display:
OUT
OT2
SP
2SP
3SP
RSP
1IN
2IN
3IN
POS
CSP
DEV
PIDSETX
2PIDSETX
ET_XX.XX
TR_XX.XX
RAMPXXOM
*Or estimated Three Position Step motor position when no slidewire
exists.
UDC 3300 Controller Product Manual
Function of Keys
Function
= Output
(Note 1)
= Output 2 (Cascade or 2-Loop
applications
= Local Setpoint
(also current SP value
when using SP ramp) (Note 2)
= Local Setpoint 2
(Note 2)
= Local Setpoint 3
(Note 2)
= Remote Setpoint
= Input 1
—when used with combinational
input algorithms
= Input 2
= Input 3
=
3 Position Step motor position when
slidewire is connected
= Computer Setpoint Override
= Deviation
= Tuning Parameter Set
= Loop 2 Tuning Parameter Set
= Elapsed Time
= Time Remaining
= Minutes Remaining in Setpoint Ramp
X=1 or 2 (Note 3)
X=1 or 2
4/00