Operator Interface; Figure 1-1 Operator Interface Displays And Indicators - Honeywell UDC 3300 Product Manual

1.2

Operator Interface

Displays and indicators
Figure 1-1
T - Accutune in progress
t - PV tune in progress
L" - Loop 2 display
I - Cascade control
C - Computer setpoint active
O - Output override active
R - Run SP ramp/program
H - Hold SP ramp/program
Indicator definition when lit
ALM - Alarm conditions exist
DI - Digital input active
3 - LSP 3 active
RSP - Remote SP or SP2 active
OUT - Control relay 1 or 2 on
Keys - See Table 1-1
4/00
Figure 1-1 shows the operator interface and defines the displays and
indicators. The function of the keys is shown in Table 1-1.
Operator Interface Displays and Indicators
Upper Display - six characters
• Normal Operation - four digits dedicated to display the process variable
• Configuration Mode - displays parameter value or selection
Lower Display - eight characters
• Normal Operation - displays operating parameters and values
• Configuration Mode - displays function groups and parameters
Indicator definition when lit
F - °Fahrenheit being used
C - °Centigrade being used
1 2 F C
ALM
DI 1 2 3
R
RSP
1 2 SP 3300
OUT
FUNCTION LOWER
LOOP 1/2 DISPLAY
SET UP
UDC 3300 Controller Product Manual
MAN - controller in manual mode
A - controller in automatic mode
MAN
3300
%
SETPOINT
MANUAL
SELECT
AUTO
RUN
HOLD
MAN and A off —
communications
option active
Deviation Bargraph
• Center bar indicates PV is
within ±1% of setpoint.
• Next bar will light if PV is
between ±1% but less than
±2% in deviation.
• If PV is equal to or greater than
±10% deviation, the center bar
plus all ten deviation bars will
light.
24157
3