Input 3 Parameters Set Up Group; Table 4-9 Input 3 Group Definitions - Honeywell UDC 3300 Product Manual

4.10 Input 3 Parameters Set Up Group

Introduction
Input 3 group prompts
Lower Display
Prompt
IN3 TYPE
ATTENTION
Changing the input type
will result in the loss of
Field Calibration values
and will restore Factory
Calibration values.
XMITTER2
IN3 HI
IN3 LO
RATIO 3
BIAS IN3
FILTER 3
4/00
These are the parameters required for Input 3: actuation, transmitter
characterization, high and low range values in engineering units, ratio,
bias, and filter.
Input 3 prompts appear on expanded models only. Prompts
ATTENTION
for Input 3 only appear if Input 2 PWA is installed and the actuation for
Input 2 is configured for one of the following types: 0-5 Vdc, 1-5 Vdc,
0-20 mA, or 4-20 mA.
Table 4-9 lists all the function prompts in the Input 3 Set Up group and
their definitions.
Table 4-9 Input 3 Group Definitions
Upper Display
Range of Setting
or Selection
DISABL
0-20mA
4-20mA
0-5 V
1-5 V
Input 3 ranges and
selections are same as for
Input 1 except Burnout and
Emissivity are not available.
UDC 3300 Process Controller Product Manual
Parameter
Definition
INPUT 3 ACTUATION TYPE – This selection determines
what actuation you are going to use for Input 3.
DISABL—Disables Input 3
0-20mA—0 to 20 milliamperes
4-20mA—4 to 20 milliamperes
0-5 V—0 to 5 volts
1-5 V—1 to 5 volts
Refer to Input 1 parameters for definitions.
117