Overview Of The Commands - Siemens SIMATIC RF650R Configuration Manual

7.7.2

Overview of the commands

The following table contains all the commands supported by the Ident profile and the
"AdvancedCMD" block.
Table 7- 19 Commands of the Ident profile
Command Command code
HEX
PHYSICAL-READ 70
PHYSICAL-WRITE 71
READER-STATUS 74
INVENTORY 69
WRITE-ID 67
KILL-TAG 6A
LOCK-TAG-BANK 79
EDIT-BLACKLIST 7A
GET-BLACKLIST 6C
READ-CONFIG 61
WRITE-CONFIG 78
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03
Parameters used
ASCII
'p' OFFSETBUFFER,
EPCID_UID, LEN_ID,
LENGTH, ADR_TAG,
MEM_BANK, PSWD
'q' OFFSETBUFFER,
EPCID_UID, LEN_ID,
LEN_DATA, ADR_TAG,
MEM_BANK, PSWD
't' OFFSETBUFFER,
ATTRIBUTES
'i' OFFSETBUFFER,
ATTRIBUTES, DURATION,
DUR_UNIT
'g' OFFSETBUFFER,
EPCID_UID, LEN_ID,
NEW-LEN_ID, PSWD
'j' EPCID_UID, LEN_ID,
PSWD
'y' EPCID_UID, LEN_ID,
PSWD, ACTION, MASK
'z' EPCID_UID, LEN_ID,
MODE
'l' OFFSETBUFFER
'a' --
'x' LEN_DATA, CONFIG
Interface to the SIMATIC controller
7.7 Programming the Ident profile
Description
Reads data from a transponder by specifying
the physical start address of the memory bank
(UHF), the length and the password.
Writes data to a transponder by specifying the
physical start address of the memory bank
(UHF), the length and the password.
Reads out the status of the reader.
Requests a list of all currently accessible tran-
sponders within the antenna range.
RF680R/RF685R:
Writes a new EPC-ID to the transponder.
RF680R/RF685R:
The transponder is permanently deactivated.
RF680R/RF685R:
The corresponding memory area of the tran-
sponder is blocked as specified.
RF680R/RF685R:
The black list is processed. The current tran-
sponder can be added, all identified transpond-
ers added, individual transponders deleted or all
transponders deleted.
RF680R/RF685R:
The entire EPC-IDs are read out from the black
list.
Reads out the parameters from the reader.
Sends new parameters to the reader.
123