Siemens SIMATIC RF650R Configuration Manual page 32

Configuration via STEP 7 (PROFINET device)
5.3 Overview of the configurable properties
Parameter
Module parameters
Configuration management
Hardware identifier / diagnostics ad-
dresses
RFID communication
General
I/O addresses
Hardware identifier
Digital inputs/outputs
General
I/O addresses
Hardware identifier
32
Functionality
Enabling/disabling read-point related diagnostics messages
Possible error messages:
0x154D - Internal firmware error
•
0x1591 - Antenna 1 not connected
•
0x1592 - Antenna 2 not connected
•
0x1593 - Antenna 3 not connected
•
0x1594 - Antenna 4 not connected
•
Loading configuration data on the reader from the STEP 7 project.
•
Saving configuration data of the reader in the STEP 7 project.
•
Hardware identifier of the reader (with a connected S7-1200/-1500).
Diagnostics address of the reader (with a connected S7-300/-400).
Address parameters of the reader
General settings
I/O address parameter ("LADDR") of the reader. This parameter is used in the
"IID_HW_CONNECT" variable.
Hardware identifier parameter ("HW-ID") of the reader. This parameter is used
in the "IID_HW_CONNECT" variable.
Address parameters of the digital inputs/outputs of the reader.
General settings
I/O address parameter of the digital inputs/outputs.
Using the set address range (I/O address), the digital inputs/outputs configured
in the WBM of the reader can be accessed.
Hardware identifier parameter of the digital inputs/outputs.
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03