XML interface
8.3 XML commands
8.3.2.11
setIO
This command sets the digital outputs of the reader.
The general settings for the response of the outputs such as "Inactivity" or "Reset time"
specified using the WBM in a base configuration (see also section "The "Settings - Digital
outputs" menu item (Page 64)").
Command
<frame>
<cmd>
</cmd>
</frame>
Reply
<frame>
<reply>
</reply>
</frame>
The error codes for negative replies ("resultCode" ≠ 0) are described in the section "Negative
XML replies (Page 211)".
162
<id> value_id </id>
<setIO>
<outValue> value_outValue </outValue>
</setIO>
<id> value_id </id>
<resultCode> 0 </resultCode>
<setIO/>
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03