Service and maintenance
9.2 Error messages
"ER"
XML/
Bloc (hex)
LED
LED
(hex)
--
0xCC
0xE4FE8C
2 Hz
0xCD
0xE4FE8D
2 Hz
0xCE
0xE4FE8E
2 Hz
0x51
0xE5FE01
--
0x52
0xE5FE02
2 Hz
0x54
0xE5FE04
--
0x55
0xE5FE05
2 Hz
0x56
0xE5FE06
--
0x57
0xE5FE07
236
Error description
Communication error between Ident profile and communications module. Handshake
•
error.
–
UDT of this communications module is overwritten by other program sections
–
Check parameter settings of communications module in the UDT
–
Check the Ident profile command that caused this error
–
Start "INIT" after correcting the error
Backplane bus / PROFIBUS DP / PROFINET error occurred
•
This error is only indicated when access monitoring has been enabled in the
PROFIBUS configuration.
–
Backplane bus / PROFIBUS DP / PROFINET bus connection was interrupted (wire
break on the bus; bus connector on the communications module was briefly un-
plugged)
–
Backplane bus / PROFIBUS DP / PROFINET master no longer addressing commu-
nications module
–
Execute "INIT"
–
The communications module has detected a frame interruption on the bus. The
backplane bus, PROFIBUS or PROFINET may have been reconfigured (e.g. with
HW Config or TIA Portal)
Firmware error
•
Possible cause: The firmware update was not run completely.
Internal communications error of the communications module/reader
•
–
Connector contact problem on the communications module / reader
–
Hardware of the communications module / reader has a defect; → Send in communi-
cations module / reader for repair
–
Start "INIT" after correcting the error
Internal monitoring error of the communications module/reader
•
–
Program execution error on the communications module / reader
–
Turn the power supply of the communications module/reader off and on again
–
Start "INIT" after correcting the error
The current command was aborted by the "WRITE-CONFIG" ("INIT" or "SRESET") com-
mand for the bus connector was pulled.
Possible causes:
Communication with the transponder was aborted by "INIT".
•
This error can only be reported if there is an "INIT" or "SRESET".
•
Incorrect sequence number order (SN) on the reader/communications module.
Incorrect sequence number order (SN) in the Ident profile
Invalid data block number (DBN) on the reader/communications module
Invalid data block number (DBN) in the Ident profile
Invalid data block length (DBL) on the reader/communications module
Invalid data block length (DBL) in the Ident profile
SIMATIC RF650R/RF680R/RF685R
Configuration Manual, 10/2015, C79000-G8976-C386-03