HEIDENHAIN iTNC 530 Service Manual page 96

Calling As of NC software version 34049x-04:
DriveDiag
9 – 96
Select the Programming and Editing operating mode.
If open: Close the program management by pressing the END button.
Note
Press the MOD key while the program manager is open calls the interface settings.
Press the MOD key.
Press the DIAGNOSIS soft key.
Press the DRIVE DIAGNOSIS soft key.
Press the DRIVEDIAG soft key. --> A new window (in addition to the window for
the machine operating modes and the window for the programming modes) is
opened:
HEIDENHAIN Service Manual iTNC 530