HEIDENHAIN iTNC 530 Service Manual page 615

MP Function and input
MP6572 Maximum permissible speed during tool measurement
Input:
0: 1000 [rpm]
MP6580.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 1)
Input:
MP6581.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 2)
Input:
MP6582.0-2 Coordinates of the TT 130 probe contact center with respect to the machine datum
(traverse range 3)
Input:
MP6585 Monitoring the position of the rotary and additional linear axes during the tool
measurement cycles
Format:
Input:
1: Axis is monitored
Bit 0 – A axis
Bit 1 – B axis
Bit 2 – C axis
Bit 3 – U axis
Bit 4 – V axis
Bit 5 – W axis
MP6586 Ref. coordinate for monitoring the position of the rotary and additional linear axes during
the tool measurement cycles
Input:
MP6586.0 A axis
MP6586.1 B axis
MP6586.2 C axis
MP6586.3 U axis
MP6586.4 V axis
MP6586.5 W axis
MP6600 KinematicsOpt: Maximum permitted change value
Input:
MP6601 KinematicsOpt: Radius deviation of the calibration sphere
Input:
July 2010
0 to 100,000 [1000 rpm]
-99 999.9999 to +99 999.9999 [mm]
-99 999.9999 to +99 999.9999 [mm]
-99 999.9999 to +99 999.9999 [mm]
%xxxxxx
0: Axis is not monitored
–99 999.9999 to +99 999.9999 [mm or °]
0.000 to 1.000 [mm]
0.010 to 0.100 [mm]
SW version
and
behavior
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
340 490-04
340 490-04
30 – 615