HEIDENHAIN iTNC 530 Service Manual page 139

Operand Description
M 4053 Probing process has been completed or canceled
M 4054 Battery voltage too low (battery warning at touch probe connection);
evaluated only during the probing process
M 4055 Enable the probing process
M 4056 NC stop in all operating modes if stylus is deflected
M 4057 Touch probe cycles active (FN17: ID990 NR2)
M 4060 Cycle for tool measurement started
M 4061 0: Measure the tool
1: Check the tool
M 4062 0: Wear tolerance not exceeded
1: Wear tolerance exceeded
M 4063 0: Breakage tolerance not exceeded
1: Breakage tolerance exceeded
M 4065 Workpiece dimensions are OK
M 4066 Workpiece must be reworked
M 4067 Workpiece is scrap
Strobe signals from the PLC to the NC
Operand Description
M 4070 Strobe signal for gear code
M 4071 Strobe signal for S code
M 4072 Strobe signal for M functions
M 4073 Strobe signal T code (P code) with TOOL CALL
M 4074 Strobe signal T code (P code) with TOOL DEF
M 4075 Transfer active with FN19
Acknowledgment of NC strobe signals
Operand Description
M 4090 Acknowledgment of "gear change completed"
M 4091 Acknowledgment of S code
M 4092 Acknowledgment of M function
M 4093 Acknowledgment of T code (P code) with TOOL CALL
M 4094 Acknowledgment of T code (P code) with TOOL DEF
M 4095 Acknowledgment of transfer with FN19
Strobe signals from the PLC to the NC
Operand Description
M 4120 - PLC positioning axis 1 to 9 active
4128
M 4130 Activation of spindle orientation, or spindle orientation has been
started with Module 9171
M 4131 Activation of Q-parameter transfer to the NC; data from D258, Q
number from W516
M 4132 Activate datum shift from D528 to D544, or call module 9230
M 4133 Starting and stopping the free rotation function
M 4134 Activation of a gear range and speed through the PLC
M 4135 Strobe marker for selecting the traverse range
July 2010
Set Reset As of SW vers.
NC NC
NC NC Not supported
as of
340 422-03,
340 480-03
NC PLC
PLC PLC
NC NC 340 422-09,
340 480-09
NC NC
NC NC
NC NC/
PLC
NC NC/
PLC
NC PLC
NC PLC
NC PLC
Set Reset As of SW vers.
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
Set Reset As of SW vers.
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
Set Reset As of SW vers.
NC/ NC/
PLC PLC
NC/ NC
PLC
PLC NC
PLC NC
PLC NC
PLC NC
PLC NC
11 – 139