HEIDENHAIN iTNC 530 Service Manual page 132

Activating the
I/O FORCE LIST
After you have created an I/O FORCE LIST file, you can save it in order to be able to call it again
Saving the
at a later date:
I/O FORCE LIST file
A saved I/O FORCE LIST file can be called again at any time:
Calling an
I/O FORCE LIST file
After having worked with the I/O FORCE LIST function, it is essential to terminate this
Deactivating and
exiting the I/O function again!
FORCE LIST
11 – 132
Now press this soft key.
ON is highlighted; the I/O-FORCE LIST is active.
If you now exit the I/O-FORCE LIST with END the following display is shown:
DANGER
The text I/O-Force is active is shown only in the PLC mode. If a machine operating
mode is displayed on the monitor (e.g., Program Run, Full Sequence), this informational text
is not visible!
Note
If you call the TABLE with the INPUTS and OUTPUTS, the "forced" inputs and outputs are
displayed in a different color (e.g., blue).
Press the PGMMGT key. --> The program management is opened and the cursor is placed on
the file MAIN_PGM.FLT in the path where the PLC main program is also located.
Press the COPY soft key.
Enter a target file (e.g., Force123.flt).
Open the I/O FORCE LIST function.
Press the PGMMGT key. --> The program management is opened.
Place the cursor on the saved I/O FORCE LIST file (e.g., Force123.flt).
Press the ENT key. --> The file is called in the I/O FORCE LIST function.
Press the EMERGENCY STOP key.
Press this soft key. --> OFF must be highlighted!
As a precaution all PLC operands in the I/O FORCE LIST with the DELETE LINE.
Exit the function I/O FORCE LIST with the END soft key.
Exit the PLC mode.
As a precaution, restart the control!
HEIDENHAIN Service Manual iTNC 530