HEIDENHAIN iTNC 530 Service Manual page 423

Functional test
By means of DriveDiag:
July 2010
DANGER
Consult the machine operator and observe the machine manufacturers's safety precautions
(setup mode, etc.)!
Switch on the machine.
Turn the feed-rate potentiometer to a low value.
Call the DriveDiag. --> See "Integrated Diagnostic Functions and DriveDiag" on page 9 – 89.
Open the following page:
Start the probing cycle with the TT (table touch probe).
Check the lamp at TT touch probe ready (X13).
When the touch probe is ready, the lamp shines green.
Deflect the tool touch probe by hand.
Check the lamp at Trigger signal (X13) of TT touch probe .
When the touch probe is deflected, the lamp shines green.
In the machine display appears the message Stylus deflected.
25 – 423