Execution Up To Nc Software 34049X-01 (Single And Dual Processor Version) - HEIDENHAIN iTNC 530 Service Manual

15.3 Execution up to NC Software 34049x-01 (Single and Dual Processor Version)

The provided ZIP file, e.g., 34049001sp2.zip) has still to be unzipped on a data medium
Unzipping the
(PC/laptop)!
ZIP File
A folder with the number of the NC software (e.g., 34049001) is created.
It includes the service pack in compressed format (e.g., 340490_001_SP2.zip).
If the control is connected to the company network and the service pack files were filed on a
Access to the
released folder of the network, you have access to these data. --> If necessary, ask the system
service pack files
administrator.
via the customer
network
Otherwise, you may also transfer the service pack from your service laptop to the control.
Transferring files
service packs from
the laptop to the
control
Loading the
service pack
July 2010
Reboot the control; the Power interrupted message is displayed.
Establish the connection between the laptop and the control. --> See "Connection Setup" on
page 13 – 172.
Select the PLC partition of the iTNC 530 and create a new folder
(e.g., PLC:\servicepacks).
Open the folder.
Transfer the folder with the service pack from your laptop to the iTNC 530.
Separate the connection to TNCremoNT.
Select the Programming and Editing operating mode.
If open: Close the program management by pressing the END button.
Note
Pressing the MOD key while the program manager is open calls the interface settings.
Press the MOD key.
Press the SP --> ITNC soft key.
A pop-up window is opened.
In the upper part of the window, set the cursor to the folder that contains the zip file of the
service pack.
Note
With the +/- key you may open and close the directory trees.
Press the ENT key. --> All ZIP files of available service packs are shown in the lower part of
the window.
Press the FILES soft key . --> The cursor changes to the lower part of the window.
15 – 221