HEIDENHAIN iTNC 530 Service Manual page 416

By means of touch probe cycles ...
Touch probe cycles
See "Touch Probes" on page 27 – 507.
Pin layout
You will find further information on touch probes in ...
Other
information
These documents can be downloaded from the HEIDENHAIN website (www.heidenhain.de).
25 – 416
Datums can be set in manual and automatic mode.
Workpiece misalignment can be compensated manually and automatically.
Workpieces can be measured automatically.
Tools can be measured automatically.
Touch probe systems can be calibrated.
The iTNC 530 User's Manual
The corresponding mounting instructions
The brochure 3-D Touch Probes for Machine Tools
HEIDENHAIN Service Manual iTNC 530