HEIDENHAIN iTNC 530 Service Manual page 145

Operand Description
D 756 Programmed rotational speed or rotational speed from the
PLC [0.001 min
D 760 Offset in tilting axes touch probe center offset [1/10 000°]
W 764 Percentage for spindle override (PLC to NC)
W 766 Percentage for feed-rate override (PLC to NC)
D 768 - 956 Value from MP4210.0 to MP4210.47
W 960 - 968 Value from MP4220.0 to MP4220.4
W 976 - 994 Value from MP4310.0 to MP4310.9
W 1002 Last PLC run-time error that occurred
W 1008 S code for minimum speed
W 1016 PLC module that was last processed erroneously
W 1018 Number of files opened by the PLC
W 1020 Number of all open files
W 1022 Error status of the last called PLC module
W 1024 Axis enabling
W 1026 Axes in position
W 1028 Axes in motion
W 1030 Current direction of traverse
W 1032 Reference marks not yet traversed
W 1034 Positive software limit switch was approached
W 1036 Negative software limit switch was approached
W 1038 Prepare to open the position control loop
W 1040 Axis-specific opening of the position control loop
W 1042 Deactivation of monitoring functions
W 1044 Actual-to-nominal value transfer
W 1046 Manual traverse in positive direction
W 1048 Manual traverse in negative direction
W 1054 Reference end position
W 1056 Lubrication pulse: Value in MP4050.x exceeded
W 1058 Reset the accumulated distance
W 1060 Axis-specific feed rate enable
W 1062 Lock the handwheel for specific axes
July 2010
–1
]
Set Reset As of SW vers.
NC/PLC NC/PLC
PLC PLC
NC/PLC NC/PLC
NC/PLC NC/PLC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
NC NC
PLC PLC
PLC PLC
PLC PLC
11 – 145