Execution As Of Nc Software 34049X-02 (Single-Processor Version) - HEIDENHAIN iTNC 530 Service Manual

15.4 Execution as of NC Software 34049x-02 (Single-Processor Version)

The provided ZIP file (e.g., 34049004sp6.zip) has still to be unzipped on a data medium (PC/
Unzipping the
laptop/USB stick)!
ZIP File
A folder with the number of the NC software (e.g., 34049004) is created.
This folder contains a subdirectory (e.g., 340490_004_SP6), of the following files:
If the control is connected to the company network and the service pack files were filed on a
Access to the
released folder of the network, you have access to these data. --> If necessary, ask the system
service pack files
administrator.
via the customer
network
Otherwise, you can also use a USB stick as data medium (or transfer the service pack from your
service laptop to the control).
Loading the
service pack
July 2010
setup.elf (previously setup.omf)
setup.ini (optional)
setup.zip
Connect the USB stick to X141 or X142 (USB interfaces of the iTNC 530).
Note
When connecting, USB memory devices that use the file system VFAT or ISO 9660
(not NTFS, or similar), are recognized automatically as of NC software version 34049x-02
with feature content level L2.
If level 2 is not set, you can transfer the service pack with TNCremoNT to the control's hard
disk See "Transferring files service packs from the laptop to the control" on page 15 – 221.
Select the Programming and Editing operating mode.
If open: Close the program management by pressing the END button.
Note
Pressing the MOD key while the program manager is open calls the interface settings.
Press the MOD key.
Enter the code number SETUP. --> A pop-up window appears.
In the upper part of the window, set the cursor to the USB data medium (or to the partition of
the control's hard disk where you have transferred the service pack with TNCremoNT).
Note
With the +/- key you may open and close the directory trees.
Now set the cursor to the folder with the designation of the NC software + service pack
(e.g., 340490_004_SP6).
Press ENT. --> The file setup.elf (previously setup.omf) is shown in the lower part of the
window.
15 – 223