HEIDENHAIN iTNC 530 Service Manual page 530

For replacement units and spare parts, ask your machine manufacturer!
Replacement units
This also applies for the NC software!
and spare parts
Please observe:
Many HEIDENHAIN units are not repaired on site but are exchanged or replaced.
Repair
These devices are exclusively repaired by HEIDENHAIN agencies. The devices are also updated
to the latest state-of-the-art and subjected to tests.
According to DIN VDE 0113 part 1 / EN 60204-1, the following must be checked after an
Checking after
electrical component has been exchanged:
replacement of
electrical
components
28 – 530
Always use original HEIDENHAIN components as replacements!
MC, HDR and drive assembly are normally equipped with the current NC software.
If you wish to keep the previously installed - older - NC software version, contact your OEM.
He can restore this version.
Please send the defective unit in its original packaging to your machine manufacturer or your
HEIDENHAIN agency.
Check whether the electrical equipment corresponds to the technical documentation.
Check whether the connections of the grounding conductor system are continuous.
Perform a functional check.
HEIDENHAIN Service Manual iTNC 530