Doctor Blade - Toshiba e-STUDIO556 Service Manual

4.8.10

Doctor blade

(1) Take out the developer material.
( P.4-73 "4.8.9 Developer material")
(2) Remove 2 screws and take off the doctor
blade.
Note:
When installing the doctor blade, butt both
edges to the protrusion on the front and rear
side frame and tighten the screw. (The
doctor sleeve gap does not need to be
adjusted.)
4.8.11 Auto-toner sensor (S12)
(1) Take out the developer material.
( P.4-73 "4.8.9 Developer material")
(2) Release the harness from the clamp and pull
out the harness.
(3) Remove 2 screws to take off the auto-toner
sensor.
© 2012 TOSHIBA TEC CORPORATION All rights reserved
Doctor blade
Screw
Fig. 4-212
Doctor blade
Fig. 4-213
Auto-toner sensor
Fig. 4-214
4 - 75
Screw
Protrusion
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4