Original Reverse Motor (Mr3) - Toshiba e-STUDIO556 Service Manual

4.12.28 Original reverse motor (MR3)

(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 3 screws and take off the original
reverse motor with the bracket.
(4) Remove 2 screws and take off the bracket
from the original reverse motor.
4.12.29 Original exit motor (MR4)
(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Disconnect 1 connector [1].
(3) Remove 1 spring [2].
(4) Loosen 2 screws [3].
e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
© 2012 TOSHIBA TEC CORPORATION All rights reserved
4 - 142
Connector
Fig. 4-403
Fig. 4-404
[3]
[1]
[3]
Fig. 4-405
[2]