Hard Disk (Hdd) - Toshiba e-STUDIO556 Service Manual

9.1.5

Hard disk (HDD)

[A] Nomal hard disk (SATA-HDD)
(1) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(2) Remove the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(3) Disconnect 1 connectors and remove 1
screw to take off the ground wire.
(4) Remove 4 screws and remove 4 washers to
take off the HDD with its bracket.
Note:
Be sure that any vibration is not transmitted
to the HDD.
(5) Remove 4 screws and take off the HDD and
the ground wire from the brackets.
[B] Security hard disk (ADI-HDD)
(1) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(2) Remove the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(3) Disconnect 1 connectors and remove 1
screw to take off the ground wire.
(4) Remove 4 screws and remove 4 washers to
take off the HDD with its bracket.
Note:
Be sure that any vibration is not transmitted
to the HDD.
e-STUDIO556/656/756/856(Ver03)
REPLACEMENT OF PC BOARDS / HDD
HDD
© 2012 TOSHIBA TEC CORPORATION All rights reserved
9 - 4
HDD
Fig. 9-9
Bracket
Fig. 9-10
HDD
Fig. 9-11