Toshiba e-STUDIO556 Service Manual page 867

(6) After the update is completed properly, the LED on the download jig blinks. The LED starts
blinking approx. 30 sec. after the update starts. It is assumed that the update has failed if it does
not start blinking even though 1 min. has passed. In this case, shut down the equipment and
check the following items. Then clear the problems and restart updating from the beginning.
• Is the download jig connected properly?
• Is the ROM installed to the download jig properly?
• Is the updating data written on the ROM of the download jig properly?
• Do the download jig, FAX board and the equipment operate properly?
(7) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.
(8) Remove the download jig, and then install the cover plate.
(9) In the FAX Clearing Mode, perform the "FAX Set Up".
• Confirm the destination setting is correct in the Setting Mode (08).
08-9000: Destination setting of the equipment
08-9001: Destination setting of the FAX machine
• Press the [ON/OFF] button while simultaneously holding down the [1] and [*] buttons.
• Key in "100".
• Press the [START] button.
Notes:
If the equipment does not work properly after the operation (8), follow the procedure below and
then perform the "Clearing the image data" in the FAX Clearing Mode to erase the image data in
the memory.
• Confirm the destination setting is correct in the Setting Mode (08).
08-9000: Destination setting of the equipment
08-9001: Destination setting of the FAX machine
• Press the [ON/OFF] button while simultaneously holding down the [1] and [*] buttons.
• Key in "102".
• Press the [START] button.
[B] Confirmation of the updated data
After the updating is completed, check each data version in Setting Mode (08) to confirm that the data
were overwritten properly.
P.11-50 "11.6 Confirmation of the updated data"
© 2012 TOSHIBA TEC CORPORATION All rights reserved
11 - 49
e-STUDIO556/656/756/856(Ver03)
FIRMWARE UPDATING
11