Toshiba e-STUDIO556 Service Manual page 372

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Table of Contents

(*1) 0: Long size 1: Middle size 2: Short size1 3:Short size 4:Post card

(*2) 0: Long size of OHP film 1: Middle size of OHP film 2: Short size1 of OHP film

3: Short size 2 of OHT film 4:Post card size of OHP film

1. Long size: 330 mm or longer (13.0 inches or longer)

Middle size: 220-239 mm (8.7-12.9 inches)

Short size1: 205-219 mm (8.1-8.6 inches)

Short size2: 160-204 mm (6.3-8.0 inches)

159 mm or shorter (6.2 inches or shorter)

2. The adjustment of "Post card" is for Japan only.

Perform the test print according to the following procedure.

Stores in memory

(*3)1: Single-sided grid pattern 3: Double-sided grid pattern 6: Gamma check patch chart for

copia (black) (Same as 04-103) 10: Gamma adjustment patch chart for copia (black) (Same 04-

Check if any transfer void is occurring. If

there is a transfer problem, try the values in

descending order as "31"

until the transfer void disappears. At the

same time, confirm if any paper jam occurs.

Also, when the aligning amount has been

increased, this may increase the scraping

noise caused by the paper and the Mylar

sheet as it is transported by the registration

roller. If this scraping noise is annoying, try to

decrease the value.

e-STUDIO556/656/756/856(Ver03)

(Not necessary for LCF)

Current value

(Test print)

Transfer void

Chapters

Table of Contents